Tidy Wall Setup: Innovative Americans Cable Satellite Box TV Wall Mount Kit

I've recently installed three TV's using this mounting method. (What can I say...I'm a neat freak...I don't want to see wires.) 1. A 32" LED TV: The mounting hole pattern on this TV worked with the basic bracket - no need to use the adapters. 2. A 42" Plasma: The mounting pattern on this TV did require the adapters. I had no trouble locating which way to install the adapters so I could attach it all to my TV. 3. A 55" Plasma: This one also needed the adapters. Again, no trouble with the installation of the Wall Mount Kit. PRO's: 1. Installation to the back of the TV is simple. 2. Easy to hang onto the wall bracket. I was worried about how hard it might be to align to the hooks, you know...while you're actually CARRYING the TV, but it was much easier than I had anticipated. (There were two of us - one on each end.) 3. Amazingly clean appearance. (We installed an electrical outlet and a cable outlet behind the TV, so that we did not have cables running up the wall. You do need to make sure you know where the wall mount will be placed on the wall, so that you know where the outlets can be without being blocked by the bracket.) CON's: 1. None so far. Observations: 1. I highly recommend putting your cable box into the wall mount, making the connections to the TV, and then routing the power & cable wires so that they exit the bottom (or sides) prior to hanging it up on the wall. It's much easier to arrange the "stuffing" while it's lying on a table, and you have access to the entire back side! 2. My remote controls (that came with the cable boxes) work well with all three installations. I did not need the "remote extender." 3. I thought we would need a lot of tilt for the bedroom TV, because the TV is high on the wall, and we'd be viewing from a reclined position. So we used the extension link to achieve the maximum angle. Wow...that's a lot of tilt angle! We had to take the extension link out, and actually set it up so that it's fully closed at the bottom, and fully open at the top...but without the extra link. This brings me to my next observation... 4. If you need to adjust the tilt angle of a heavy TV...take it off the wall first! We thought it would be easier to do while it was hanging on the wall...with one of us holding it in position, and one of us removing & re-installing the screws. It's NOT easier!